Erico EK16 Burial Grounding Clamp Parallel

The new EK16 Direct-Burial Ground Clamp from ERICO is a time-saving, cost-effective versatile product that combines four clamps into one. This unique bronze-alloy grounding clamp with bronze screws consolidates separate rebar clamps, ground rod clamps, water pipe clamps and direct-burial water pipe clamps into one product, enabling contractors to save room on their trucks and distributors to save room on their shelves.The UL-listed product can be used with rebar, water pipes and ground rods. The clamp cuts installation time by allowing the contractor to pre-set the clamp on a piece of rebar or water pipe. After all of the clamps have been set, the ground conductor can then be installed using the clamp’s unique “lay-in” feature. Rather than threading the ground wire through a hole to make a continuous loop, the contractor can simply lay the conductor in the channel and tighten the setscrew without any time-consuming threading.

Highlights :

• Lay-in feature cuts installation time

• Bronze alloy construction with bronze screws

• Approved for direct burial in earth and concrete

• Pipe range from 1/2” (12.7 mm) to 1” (25.4 mm)

• Rebar range from 4 (10 mm) to 8 (25 mm)

• Ground rod range from 1/2” (12.7 mm) to 1” (25.4 mm)

• Conductor range from 10 (5.5 mm sq) to 2 (25 mm sq)

• UL listed